A home laundry room with a new washer and dryer going in and sage green cabinets, seen close at the appliance being installed.

Brooklyn, New York Metro

Appliance installation in Park Slope.

Park Slope brownstones divided into duplexes and floor-throughs often keep the kitchen on the parlor floor above a high stoop, and a delivery there climbs the stoop and turns through a vestibule with two sets of doors, so both are measured and the inner one is often lifted off.

(844) 638-8309

Mon–Sat, 8am–8pm

Brooklyn
Three things about Park Slope
10 installations we do here

Book a visit

Three short steps, about a minute.

or call (844) 638-8309

What Park Slope does
to an appliance.

Park Slope's east-west side streets are lined with brownstones and apartment buildings, while Fifth Avenue and Seventh Avenue carry its commercial traffic instead.

Numerous mansions and rowhouses went up in the neighborhood's eastern section in the 1880s, after Prospect Park was completed, and much of that stock is now protected by the Park Slope Historic District, both a National Historic District and a New York City landmark district.

The neighborhood's building stock fell into decline in the mid-20th century and was renovated after gentrification took hold starting in the 1960s.

All of New York Metro

Older housing stock

Historic districts often review changes to a house's outside walls, so a new hood cap or laundry vent may need approval before a hole is cut, and an installation there tries the existing openings first.

Family houses

Where children are in the house, no cooking unit is set in place without its anti-tip bracket, and an installation there fixes the bracket, engages the leg and tests it by tilting the unit gently forward before the crew leaves.

Mixed housing

A buyer moving into an older house with appliances of mixed ages often replaces them one at a time, and each installation there notes what the next will need, a new circuit, a longer duct or a wider opening, so later work is planned ahead.

A visit in
Park Slope.

Four steps from the call to a working appliance in Park Slope, Brooklyn.

What installations cost

01The opening and the hookups, checked first
02Connected the way the instructions say
03Set in, leveled and secured
04A first run with you there

When an appliance
cannot wait in Park Slope.

In Park Slope as anywhere, these five signs follow a connection that is not safe to run on, so the new appliance stays off until the hookup is put right: gas in the air after the gas connector went on, water on the floor after a supply or drain connection, a burning smell or a tripped breaker on the very first run, and a laundry exhaust that is crushed, pulled loose or blowing lint into the room.

All 17 problems