A home kitchen with a new refrigerator being set in place and gray slab cabinets, seen close at the appliance being installed.

Manhattan, New York Metro

Appliance installation in Upper West Side.

The neighborhood's street grid runs on a diagonal where Broadway crosses the other avenues in its southern half, then straightens to run parallel to them above 78th Street, a layout that shapes how a block-by-block delivery route has to be planned.

(844) 638-8309

Mon–Sat, 8am–8pm

Manhattan
Three things about Upper West Side
10 installations we do here

Book a visit

Three short steps, about a minute.

or call (844) 638-8309

What Upper West Side does
to an appliance.

The stretch between 96th and 110th Streets, once called the Bloomingdale District, sits at the edge of Morningside Heights and still carries a different building character from the blocks nearer Lincoln Center to the south.

New corporate towers and condominiums such as the Time Warner Center at Columbus Circle and the Riverside South complex sit alongside the neighborhood's older Central Park West buildings, mixing recent high-rise construction with prewar stock.

All of New York Metro

Tower living

Gas is rare in newer towers, so a buyer choosing a cooking appliance for a condo usually picks electric or induction, and the installation checks that the kitchen's circuit and outlet match the new unit's data plate before it is carried up.

Tight openings and walk-ups

In a small kitchen a new unit's depth matters as much as its width, and an installation there checks that its doors swing past the counter edge and the neighboring handles, since a model a few inches too deep can block a walkway or a drawer.

Older housing stock

Historic districts often review changes to a house's outside walls, so a new hood cap or laundry vent may need approval before a hole is cut, and an installation there tries the existing openings first.

A visit in
Upper West Side.

Four steps from the call to a working appliance in Upper West Side, Manhattan.

What installations cost

01The opening and the hookups, checked first
02Connected the way the instructions say
03Set in, leveled and secured
04A first run with you there

When an appliance
cannot wait in Upper West Side.

In Upper West Side as anywhere, these five signs follow a connection that is not safe to run on, so the new appliance stays off until the hookup is put right: gas in the air after the gas connector went on, water on the floor after a supply or drain connection, a burning smell or a tripped breaker on the very first run, and a laundry exhaust that is crushed, pulled loose or blowing lint into the room.

All 17 problems