ApplianceInstallation.center (844) 638-8309Mon–Sat, 8am–8pm Book a visit
An installation instruction booklet with plain diagrams and no readable text open on a kitchen counter.

Read first, book second

Appliance
guides,
read first.

An appliance installation guide is only useful if it answers the question you actually have, so these are split by what you are trying to find out — is this worth paying for, what is that noise, what can I check myself — rather than by which part of the appliance it concerns.

(844) 638-8309

Mon–Sat, 8am–8pm

  • 18 guides
  • 6 sections
  • No booking needed

Book a visit

Three short steps, about a minute.

or call (844) 638-8309

Work out what
you are dealing with.

Split by what you are trying to find out rather than by what part of the appliance it concerns.

All 18 guides
A new dishwasher sitting crooked in its opening, the counter gap uneven.
Why a brand-new appliance misbehaves in its first days

When a new install goes wrong

A finger on the control panel of a new washer, the display dark.
Measure first, then read the first week

First checks and setup codes

A panel-ready dishwasher beside a stainless one on a showroom floor.
Who installs it, which fuel, which front

Decisions before the install

An installation booklet and a receipt folder on top of a new dryer.
The first month of a new appliance

After the install

A yellow-coated gas connector at a closed shutoff valve behind a range.
Connectors, leak tests, brackets and circuits

Gas, power and water at the install

A tape measure stretched across an empty cabinet opening.
The opening, the path in and the rough-ins

Get the space ready

Reading did not fix it?

The work itself

Every guide here ends in the same place: what a technician actually does about it, in the order it gets done.

10 kinds of workCheapest cause firstWhat a visit costs See what we do

Trying to budget for the install as well as the appliance? The cost has a page of its own, since it turns on the opening, the fuel and the hookups already in place — appliance installation cost.

Not sure
where to start?

People buying a new appliance tend to ask the same four things before it arrives. The guides below answer them: how to measure the opening and the way in before ordering, what a gas hookup and a propane conversion involve, what the first week of a new appliance should look like, and whether to take the store's installation or book it separately.

Or start from the symptom

Will it fit the opening and the doorwayMeasure before you order: the opening, the swing and the hookups

The old unit is the wrong thing to measure. What to record instead, which clearances to subtract, and the three photos that save a second trip.

Gas, propane and the leak testGas connectors, conversion kits and the leak test: what happens at a gas hookup

From the shutoff valve to the appliance regulator: which connector the makers allow, how natural gas and propane differ, why altitude matters and how a hookup is proven tight.

What is normal in the first few daysThe first week after installation: what to check, and on which day

Thermometers on day two, water joints on day three, flame color and feet by day five. A short schedule that catches a connection that was nearly right while help is still easy to reach.

The store's crew or someone independentStore delivery install or an independent installer: matching the route to the job

A straight swap on sound hookups suits delivery with installation. A fuel change, a built-in or an online purchase usually does not. The questions to put in writing either way.

When reading
is not enough.

If the checks in a guide did not settle it, a technician picks up from there. The visit, stop by stop.

What installations cost
  1. 01The opening and the hookups, checked first
  2. 02Connected the way the instructions say
  3. 03Set in, leveled and secured
  4. 04A first run with you there

When there is
no time to read.

These five signs follow a connection that is not safe to run on, so the new appliance stays off until the hookup is put right: gas in the air after the gas connector went on, water on the floor after a supply or drain connection, a burning smell or a tripped breaker on the very first run, and a laundry exhaust that is crushed, pulled loose or blowing lint into the room. Each page puts the causes in the order worth checking, and says when to stop and book.

All 17 problems
A quiet home kitchen with a newly installed stainless gas range pulled slightly out from the wall, every burner off and its knobs at the off position, the new yellow-coated flexible gas connector visible behind it running to a wall valve, a kitchen window standing open with the curtain moving, seen from the doorway. Hazard after a hookup

Gas Smell After a Hookup: Leave the House, Then Call

6 causes, cheapest first

 A kitchen floor in front of a newly installed dishwasher, its kick plate removed and leaning against the cabinet, a small spreading pool of clear water on light wood flooring below the open toe space, a folded dry towel lying nearby untouched, the sink cabinet door open beside it with a chrome stop valve visible, seen low from across the room. Hazard after a hookup

Water Leak After an Install: Close the Supply Valve First

6 causes, cheapest first

 A home kitchen with a newly installed stainless wall oven, its door closed and its display dark, a thin wisp of pale smoke hanging near the top vent of the oven trim, a torn corner of packing foam lying on the counter beside it, an open window behind with light curtains, seen from across the room. Hazard after a hookup

Burning Smell on the First Run: When It Is Normal and When to Stop

6 causes, cheapest first

 A gray residential breaker panel on a clean utility room wall with its door open, one breaker handle in the tripped middle position among a row of others, a new white laundry pair visible through the doorway beyond, soft daylight, seen close and level. Hazard after a hookup

Breaker Trips on the First Run: Leave It Off and Find Out Why

6 causes, cheapest first

 A home laundry room seen from the side, a new front-loading dryer standing still with its door closed and its display dark, a silver metal transition duct hanging loose and disconnected from the round wall collar behind it, a little gray lint scattered on the floor and the wall behind the machine, the power cord unplugged and lying on the floor. Hazard after a hookup

Laundry Exhaust Crushed, Loose or Blowing Into the Room

6 causes, cheapest first
A family unpacking groceries into a newly fitted kitchen, the fresh appliances set flush in their openings.
For the heart of your home.

Questions about
the guides.

Can a guide replace a professional installation?
For the planning, often. Measuring the opening and the path in, reading a spec sheet, checking which outlet and valve are behind the space and clearing the way before delivery are things any owner can do. The guides say plainly where a gas connection, a new circuit or a drain tie-in belongs to an installer or a licensed trade.
Are the installation guides written for one brand?
Mostly not. Whoever made the appliance, a gas connector, a high drain loop and a rigid exhaust run go in by the same rules, and the guides are organized around those tasks. Where a maker asks for something different the guide notes it, and your own installation instructions always come first.
Should I read a guide or a problem page?
If something is already wrong after the install, a problem page is faster, since it starts from the sign. The guides are for the stage before: whether a model will fit, what must be ready, who should install it and what the first weeks should look like.
Where do the facts in the installation guides come from?
Every fact that can be checked names where it came from: installation instructions and owner's manuals from the makers, federal agencies such as the CPSC on range tip-overs, dryer venting and carbon monoxide, ENERGY STAR and DOE on efficiency, and fire-safety bodies on laundry and kitchen fires. What comes from our own installs is marked as such.

Back to your everyday

Let’s get your appliance working again.

Three short steps online, or one call. Tell us what you are seeing and pick a window that works.

Schedule an installation Call (844) 638-8309
(844) 638-8309 Schedule an installation