ApplianceInstallation.center (844) 638-8309Mon–Sat, 8am–8pm Book a visit
A panel-ready dishwasher beside a stainless one on a showroom floor.

Who installs it, which fuel, which front

Decisions before the install
guides.

The calls a buyer makes before delivery: the store's installation or an independent one, gas or electric when a kitchen changes, and a panel-ready front or a finished one, with what each choice asks of the install.

(844) 638-8309

Mon–Sat, 8am–8pm

  • Three guides
  • Read before you book
  • Says where to stop

Book a visit

Three short steps, about a minute.

or call (844) 638-8309

Decisions before the install,
guide by guide.

Every appliance decision has an installation decision hiding inside it. The fuel under a cooking appliance decides which trades come before the cabinets. The front on a built-in decides how many visits the fitting needs. The way the installation is bought decides who answers for the connection once the crew has left.

All 18 guides
Two technicians seen from behind wheel a new stainless refrigerator on a padded dolly through a front hallway while the old refrigerator waits strapped to a second dolly by the door, moving blankets on the floor, a carton at the edge, indoors.
5-minute read

Store delivery install or an independent installer: matching the route to the job

A straight swap on sound hookups suits delivery with installation. A fuel change, a built-in or an online purchase usually does not. The questions to put in writing either way.

In a kitchen under remodel, a technician seen from the shoulders down tightens a new yellow-coated gas connector onto the shutoff valve behind a freestanding gas range, the gas range pulled forward from its opening on a protective mat, a coil of electrical cable capped in a box on the open wall, indoors.
5-minute read

Gas or electric when the kitchen changes: what each fuel asks of the install

A 240-volt circuit, a gas branch with a shutoff, or both for dual fuel. What has to be in the wall for each choice, and the order the trades should work in.

A technician seen from behind and shoulders down holds a spirit level against a freshly hung wood cabinet panel on a panel-ready refrigerator column, the refrigerator column's panel aligned with the cabinet doors beside it, a drill and screws on a moving blanket at the edge, indoors.
5-minute read

Panel-ready or finished front: what each choice asks of the install

One front goes in and runs in a single visit. The other adds a cabinetmaker, a panel built to weight and thickness limits, and usually a second trip.

Who installs it, which fuel, which front.

The guides in this section compare those choices from the installer's side: what must be in the wall, what has to be ordered or built, who needs to be on site and in which order, and what each option commits the kitchen or laundry room to for the years after. They are written for someone who is still deciding, while changing course costs nothing.

Figures come from the makers' installation instructions, ENERGY STAR and EPA, with the source under each claim. Where the right answer depends on the home, such as the panel's capacity, the gas supply or the local code, the guide says who can answer it rather than pretending to.

We are an independent installer, not the maker's or a store's, and these guides say what we would ask either one. Where a choice means fresh wiring, new gas piping or a relocated outlet, the guides mark the point at which a licensed electrician or plumber takes over before we arrive.

Not sure where to start?

The short answerStore delivery install or an independent installer: matching the route to the job

A store delivery install connects to the hookups already in place on a scope set by the order; an independent appliance installer is booked for the site.

The short answerGas or electric when the kitchen changes: what each fuel asks of the install

Choosing gas or electric cooking during a remodel is an installation decision as much as a kitchen one.

The short answerPanel-ready or finished front: what each choice asks of the install

Panel-ready or finished front is a choice about the installation as much as the look.

When reading
is not enough.

If the checks in these guides did not settle it, the visit picks up from there, stop by stop.

What installations cost
  1. 01The opening and the hookups, checked first
  2. 02Connected the way the instructions say
  3. 03Set in, leveled and secured
  4. 04A first run with you there

The problems
these answer.

Each has a page of its own, with the causes in the order worth checking.

All 17 problems
Close view at the wall behind a laundry space, a heavy black four-prong appliance cord plug held a few inches away from an older three-slot wall receptacle, the mismatch between prongs and slots clear, a strip of painted drywall and the top of a white dryer edge in soft focus. Problem

Plug Does Not Fit the Outlet: Cords, Receptacles and Circuits

6 causes, cheapest first

 A kitchen with a new stainless French door refrigerator still on its low appliance dolly, stopped halfway into a cabinet opening whose top edge is visibly too low for it, a yellow tape measure lying extended along the counter beside it, cardboard corner guards at the edge of the frame, even daylight. Problem

Unit Too Big for the Opening: Cutout, Depth and the Delivery Path

6 causes, cheapest first

 A quiet home kitchen with a newly installed stainless gas range pulled slightly out from the wall, every burner off and its knobs at the off position, the new yellow-coated flexible gas connector visible behind it running to a wall valve, a kitchen window standing open with the curtain moving, seen from the doorway. Hazard after a hookup

Gas Smell After a Hookup: Leave the House, Then Call

6 causes, cheapest first

 Close view of the burner of a newly installed stainless gas cooking surface, one round burner cap sitting visibly crooked on its brass head with a gap on one side, the white ceramic igniter tip beside it, cast iron grates around it, every burner off, soft daylight. Problem

Igniter Clicking After a Gas Hookup: Air in the Line or a Wet Cap

6 causes, cheapest first
A family unpacking groceries into a newly fitted kitchen, the fresh appliances set flush in their openings.
For the heart of your home.

Questions about
decisions before the install.

When should the installation be considered in an appliance choice?
Before ordering. A fuel change, a panel-ready front or a new location all require work that has to be scheduled ahead of the delivery date.
Does the way I buy installation change the result?
It changes who answers for the connection and what parts are included. Put the questions about connectors, cords, brackets and haul-away in writing either way.
Which choice adds the most work to installation day?
A change of fuel, because it adds a supply and removes another. A panel-ready front comes next, because it adds a cabinetmaker and usually a second visit.
Can a site check help before I decide?
Yes. A pre-installation visit looks at the opening, the path in and every connection against the models you are considering.

The other
sections.

Split by what you are trying to find out rather than by which part of the appliance it concerns.

All guides
A new dishwasher sitting crooked in its opening, the counter gap uneven.
Why a brand-new appliance misbehaves in its first days

When a new install goes wrong

A finger on the control panel of a new washer, the display dark.
Measure first, then read the first week

First checks and setup codes

An installation booklet and a receipt folder on top of a new dryer.
The first month of a new appliance

After the install

A yellow-coated gas connector at a closed shutoff valve behind a range.
Connectors, leak tests, brackets and circuits

Gas, power and water at the install

A tape measure stretched across an empty cabinet opening.
The opening, the path in and the rough-ins

Get the space ready

Not sure which section?

Start from your question

The four questions most visits start with, each with the guide that answers it.

18 guidesWhere to start Where to start

Back to your everyday

Let’s get your appliance working again.

Three short steps online, or one call. Tell us what you are seeing and pick a window that works.

Schedule an installation Call (844) 638-8309
(844) 638-8309 Schedule an installation