A home kitchen with a new refrigerator being set in place and gray slab cabinets, seen close at the appliance being installed.

Manhattan, New York Metro

Appliance installation in Tribeca.

Tribeca's converted warehouses often have an elevator that opens straight into the loft, which makes the delivery easy, but the old structure and the building's rules can limit where a new vent or gas line may pass, so an installation there follows the routes the board has already approved.

(844) 638-8309

Mon–Sat, 8am–8pm

Manhattan
Three things about Tribeca
10 installations we do here

Book a visit

Three short steps, about a minute.

or call (844) 638-8309

What Tribeca does
to an appliance.

Tribeca's mid-19th-century building boom put up large numbers of store and loft buildings along Broadway in the 1850s and 1860s to hold the neighborhood's dry-goods and textile trade, not to house residents.

Those cast-iron and masonry loft buildings later became artist lofts and, more recently, residential conversions, carrying freight doors and service cores built for cargo rather than for a home.

A 1973 zoning dispute over converting the neighborhood's manufacturing lofts into artist residences shaped a special zoning designation that still governs many of its building conversions today.

All of New York Metro

Tower living

Gas is rare in newer towers, so a buyer choosing a cooking appliance for a condo usually picks electric or induction, and the installation checks that the kitchen's circuit and outlet match the new unit's data plate before it is carried up.

Cutouts and panel-ready fits

A specified kitchen is drawn around exact cutouts, and an installation there compares each opening against the spec sheet of the model actually delivered, since a late change of make can leave a gap or an opening too tight by a fraction of an inch.

Older housing stock

An old kitchen's gas stub, water valve and outlet were placed for appliances of another era, and fitting a new unit there often calls for a longer connector or a moved valve, with any new line or circuit left to a licensed plumber or electrician first.

A visit in
Tribeca.

Four steps from the call to a working appliance in Tribeca, Manhattan.

What installations cost

01The opening and the hookups, checked first
02Connected the way the instructions say
03Set in, leveled and secured
04A first run with you there

When an appliance
cannot wait in Tribeca.

In Tribeca as anywhere, these five signs follow a connection that is not safe to run on, so the new appliance stays off until the hookup is put right: gas in the air after the gas connector went on, water on the floor after a supply or drain connection, a burning smell or a tripped breaker on the very first run, and a laundry exhaust that is crushed, pulled loose or blowing lint into the room.

All 17 problems