

Manhattan, New York Metro
Appliance installation in SoHo.
Almost all of SoHo sits inside the SoHo–Cast Iron Historic District, landmarked by the city in 1973 and extended in 2010, covering about 500 buildings across 26 blocks.
Mon–Sat, 8am–8pm
- Manhattan
- Three things about SoHo
- 10 installations we do here
Book a visit
Three short steps, about a minute.
or call (844) 638-8309
Loading appointment form…
The appointment form couldn’t load. Please try again.
What SoHo does
to an appliance.
Many of the district's side streets are still paved in Belgian block rather than smooth asphalt, a surface that can make rolling a hand truck or an appliance dolly to a doorway slower than on a standard street.
SoHo's cast-iron buildings were built for 19th-century manufacturing and warehousing use before being converted into the residential lofts that now fill the district.
All of New York MetroOlder housing stock
Older houses have narrow doors, tight stair turns and wood floors that give underfoot, so installing a new appliance there starts with the carry: doors lifted off their hinges, the floor covered and a dolly path chosen that spares the old trim.
Tower living
A tower installation is booked around the freight elevator: the building sets the slot, the cab's inside depth decides whether a tall unit rides upright, and hall floors and walls are padded before the crate leaves the loading dock.
Tight openings and walk-ups
In a small kitchen a new unit's depth matters as much as its width, and an installation there checks that its doors swing past the counter edge and the neighboring handles, since a model a few inches too deep can block a walkway or a drawer.
A visit in
SoHo.
Four steps from the call to a working appliance in SoHo, Manhattan.
What installations cost- 01The opening and the hookups, checked first
- 02Connected the way the instructions say
- 03Set in, leveled and secured
- 04A first run with you there
When an appliance
cannot wait in SoHo.
In SoHo as anywhere, these five signs follow a connection that is not safe to run on, so the new appliance stays off until the hookup is put right: gas in the air after the gas connector went on, water on the floor after a supply or drain connection, a burning smell or a tripped breaker on the very first run, and a laundry exhaust that is crushed, pulled loose or blowing lint into the room.
All 17 problems
Gas Smell After a Hookup: Leave the House, Then Call
6 causes, cheapest first
Water Leak After an Install: Close the Supply Valve First
6 causes, cheapest first
Burning Smell on the First Run: When It Is Normal and When to Stop
6 causes, cheapest first
Breaker Trips on the First Run: Leave It Off and Find Out Why
6 causes, cheapest first
Laundry Exhaust Crushed, Loose or Blowing Into the Room
6 causes, cheapest first
Near SoHo.
5 more in Manhattan, 12 across New York Metro, each with its own appliance installation page.
All of New York MetroBack to your everyday
Appliance trouble in SoHo?
Book with the street, what you are seeing and the model number — an appliance technician covering Manhattan takes it from there.