A bright kitchen during an installation, a new stainless French door refrigerator on a low four-wheel appliance dolly being eased toward an empty cabinet opening, a technician seen from behind and shoulders down guiding it with one hand on the side of the cabinet, a folded moving blanket and a coil of new braided water line on a protective floor runner, cardboard corner guards at the edge of the frame, even daylight.

Bertazzoni
Appliance Installation

A Bertazzoni install is usually a pro-style gas or dual-fuel range with its matching hood, and sometimes the column refrigeration and dishwasher beside it.

(844) 638-8309

Mon–Sat, 8am–8pm

  • 3 appliance types
  • 5 problems we see
  • 2 error codes

Book a visit

Three short steps, about a minute.

or call (844) 638-8309

Bertazzoni appliances,
specifically.

Bertazzoni's US lineup runs from ranges and cooktops to built-in dishwashers and a refrigeration line, and its refrigerator manual carries two settings an installer checks before handing a new unit back: a Demo Mode built for store floors that stops the compressor while the display keeps running, and a Sabbath Mode meant for religious observance rather than a cooling problem.

The Bertazzoni lineup

What is particular
to Bertazzoni.

Bertazzoni's US range for this site covers ranges, cooktops and wall ovens, built-in refrigeration, and built-in dishwashers, all sold with the maker's own installation and use manuals.

Demo Mode can leave a new cold-storage unit looking normal but never cooling

Bertazzoni's own manual says a unit in Demo Mode can seem like it is working while it makes no cool air at all, and warns that the mode stays on even through a power cycle, so it has to be exited deliberately with the button sequence the manual lists.

Sabbath Mode is entered and confirmed the same way

The same control panel toggles Sabbath Mode with a different button combination, and shows 'On' or 'OF' on the display for five seconds before returning to the normal screen, which an installer can use to confirm which mode is actually active.

A four-hour wait is built into the first power-up

Bertazzoni's install instructions have the refrigerator plugged in four hours after it is set in place, giving the refrigerant time to settle in the compressor, and only then have the household run it for six hours before it is loaded with food.

Clearance is measured on both sides and above

The manual calls for clearance on the sides of the cabinet and above the refrigerator so air can circulate around it, tying a slow first cool-down directly back to a cabinet opening that was cut too tight rather than to the compressor itself.

Parts

Bertazzoni's refrigerator water filter is a specific SKU sold through Encompass Parts, and the manual calls for a full flush of the water line after that filter goes in, before the icemaker or dispenser is treated as finished.

Repair or replace

A new Bertazzoni refrigerator that will not cool is worth checking for Demo Mode before anything else, since the manual describes it as a setting rather than a failure and it can be exited with a button sequence rather than a technician visit.

Book your Bertazzoni visit

Not a
Bertazzoni?

Bertazzoni is one of 37 appliance makes on this site. The other 36 each have a page of their own.

All 37 brands
A family unpacking groceries into a newly fitted kitchen, the fresh appliances set flush in their openings.
For the heart of your home.

Questions about
Bertazzoni appliances.

Why does a new Bertazzoni cold-storage unit run but never get cold?
Check the display for Demo Mode first. Bertazzoni's own manual says this store setting can make the refrigerator look like it is working while it makes no cool air, and it stays on even if the power is cycled, so it needs the manual's own exit sequence.
How is Sabbath Mode different from Demo Mode on a Bertazzoni cold-storage unit?
Sabbath Mode still runs the compressor and cooling normally; it only changes how the door and controls respond, which is why the display briefly confirms 'On' or 'OF' when it is toggled rather than staying blank the way Demo Mode leaves the unit uncooled.
How long after delivery can a Bertazzoni cold-storage unit be plugged in?
Bertazzoni's installation steps call for a four-hour wait after the unit is set in its final spot before it is connected to power, so refrigerant that shifted during the move has time to settle back into the compressor.

Back to your everyday

Book your Bertazzoni visit.

Have the appliance's model number ready — on Bertazzoni it decides which parts come on the first visit.

(844) 638-8309 Schedule an installation