ApplianceInstallation.center (844) 638-8309Mon–Sat, 8am–8pm Book a visit
A kitchen during an installation, a new stainless built-in dishwasher halfway slid into its opening under a stone counter, its kick plate removed, a technician seen from behind and shoulders down on one knee guiding a gray drain hose and a braided supply line through the hole in the side cabinet, the sink cabinet doors open beside him, a flashlight on the floor, even daylight.

Cove
Appliance Installation

Cove makes dishwashers only, so every Cove install is a dish care job: the drain, the supply, the mounting and a panel that matches the cabinets.

(844) 638-8309

Mon–Sat, 8am–8pm

  • 1 appliance types
  • 4 problems we see
  • 4 error codes

Book a visit

Three short steps, about a minute.

or call (844) 638-8309

Cove appliances,
specifically.

Cove sells only a dish care line, and its own use-and-care guide ties three of its most visible on-screen alerts directly to the hookup: a drain line routed too high or still carrying a disposal knockout plug, a water supply left closed or kinked, and two display settings — showroom and Sabbath — that a homeowner can mistake for a problem on day one.

The Cove lineup

Builds1 appliance type

Dish care

Called out forDrain Backing Up After an Install: Plug, Loop and Standpipe

and 3 more problems on Cove

Installations we do10 installations, on any make

Pre-installation site check · Gas hookup and leak check · Water supply and shutoff connection · Drain and air gap connection

Error codesError 800115 · Error 560186 · Sabbath · Showroom Mode

4 Cove codes with a page of their own

The Cove
lineup.

Cove builds 1 of the 4 appliance types this site covers. Which one decides how the visit is planned.

All appliance types
Dish care machine

Dish care

2 of the problems we see on Cove come up on it Dish care installation

What is particular
to Cove.

We take on Cove dish care only; Cove does not sell a cold storage, cooking or laundry line in the US.

A numbered drain alert with an installation checklist behind it

Cove's own manual ties one numbered alert to the drain line and air gap being clear, a waste-disposal knockout plug being removed, and the drain line staying under a stated height above the appliance floor — all installation checks, not parts.

A separate numbered alert for the water supply itself

A second alert in the same manual is resolved by confirming the water supply is fully open and that the supply line has no kink, which Cove documents as the complete fix before anything else is considered.

Two settings that must both be off before troubleshooting starts

Cove's own troubleshooting for a unit that will not operate asks the installer to confirm the child lock, Sabbath mode and showroom mode are all off before looking at anything else, since any one of the three can look identical to a dead control panel.

A Sabbath setting that survives a power outage

Cove documents its Sabbath mode as remaining active even after a power interruption, so a unit that returns to that same quiet state after the power comes back on is behaving exactly as designed, not malfunctioning.

Parts

Cove's own manual resolves both of its documented installation alerts with a line check rather than a part — the drain line's height and clearance, the water line's position and kinks — before any parts ordering would apply.

Repair or replace

The installation alerts documented here — a drain line rerouted, a knockout plug removed, a water valve opened, a showroom or Sabbath setting turned off — are all resolved without a part. None of it is a repair-or-replace decision.

Book your Cove visit

What we are
called out for.

On Cove, most often drain backing up after an install: plug, loop and standpipe.

All problems

Cove error codes

All Cove codes
Close view into the open tub of a newly installed dishwasher under a stone counter, its racks pulled out, a layer of cloudy standing water covering the filter at the bottom of the tub, the open sink cabinet beside it showing a gray drain hose lying flat along the cabinet floor instead of rising in a loop, soft daylight.

Drain Backing Up After an Install: Plug, Loop and Standpipe

6 causes, cheapest first

 A gray residential breaker panel on a clean utility room wall with its door open, one breaker handle in the tripped middle position among a row of others, a new white laundry pair visible through the doorway beyond, soft daylight, seen close and level. Hazard after a hookup

Breaker Trips on the First Run: Leave It Off and Find Out Why

6 causes, cheapest first

 Close view at the bottom corner of a newly installed stainless freestanding range, the kick drawer removed, one threaded leveling leg visible turned partway out, a small spirit level lying on the floor beside it with its bubble off center, a strip of light wood floor and the edge of a cabinet, soft daylight.

New Appliance Not Level: Rocking Cabinets and Uneven Gaps

6 causes, cheapest first

 Close view of the dark control panel of a newly installed white front-loading laundry machine, one abstract wave-shaped symbol glowing amber among unlit icons, a strip of protective blue film still on the edge of the panel, the door glass blurred below, soft daylight.

Appliance Installation Code on a New Unit: Setup Modes and Hookup Messages

8 causes, cheapest first

Not a
Cove?

Cove is one of 37 appliance makes on this site. The other 36 each have a page of their own.

All 37 brands

Cove appliance installation,
where we come out.

9 metros, each with its own page.

All service areas

Tampa BayFL · 31 areas

OrlandoFL · 30 areas

Miami / South FloridaFL · 47 areas

New York MetroNY · 75 areas

HoustonTX · 36 areas

ChicagoIL · 50 areas

Los AngelesCA · 95 areas

San DiegoCA · 31 areas

San Francisco Bay AreaCA · 74 areas

A family unpacking groceries into a newly fitted kitchen, the fresh appliances set flush in their openings.
For the heart of your home.

Questions about
Cove appliances.

A new dish care machine shows a numbered alert and won't drain. What does Cove's manual say to check?
Cove's own guidance for this alert asks first whether the drain line and air gap are clear of debris, then whether a waste-disposal knockout plug was left in place, and finally whether the drain line is kinked or routed higher than the stated limit above the appliance floor.
The display shows a different numbered alert and the machine won't fill. Is that a valve failure?
Cove's documented fix for this alert is simpler than that: confirm the water supply is fully open and that the supply line isn't kinked. Both are hookup checks, not signs that a valve inside the appliance has failed.
The dish care machine seems completely unresponsive after delivery. What should be ruled out before booking a repair visit?
Cove's own troubleshooting for a non-responsive unit asks that the child lock, Sabbath mode and showroom mode all be checked and turned off first, since any of the three can make a fully working control panel look dead.

Back to your everyday

Book your Cove visit.

Have the appliance's model number ready — on Cove it decides which parts come on the first visit.

Schedule an installation Call (844) 638-8309
(844) 638-8309 Schedule an installation