

Old Appliance Disconnect and Removal
The old unit shut off, disconnected, capped and carried out, its opening cleaned for the new one.
Mon–Sat, 8am–8pm
- Low cost band
- 5 steps on the visit
- 4 problems it answers
Book a visit
Three short steps, about a minute.
or call (844) 638-8309
Loading appointment form…
The appointment form couldn’t load. Please try again.
What the old appliance disconnect and removal
involves.
An old appliance disconnect and removal clears the way for the new unit without leaving a hazard behind. It begins with the shutoffs: the breaker for anything hard-wired or on a heavy circuit, the water valve for anything that fills, and the gas valve for anything that burns. Each is closed and tested before a connection is loosened. A gas connector is removed and the valve outlet capped if the new appliance is not going on the same day, and the capped valve is leak-tested. A water line is disconnected into a bucket and capped or left with its valve closed and dry. A drain hose comes off the disposer or the tailpiece without leaving an open hole in the drain. Hard-wired power is disconnected at the junction box and the wires left capped inside a closed box. Then the old unit is emptied, its doors taped shut, and it is walked out on sliders or a dolly over floor protection, taking the path measured in advance. Refrigerators, freezers and other units with refrigerant need responsible disposal; many local utilities and haulers recover it, and the options in your area are discussed before the day. The opening is vacuumed and wiped, and the floor under it is checked for old leaks.
How the visit goesWhat it usually costsLow · Old appliance shut off, disconnected, capped and carried out, opening cleaned, disposal or recycling arranged
A plugged-in unit on the ground floor is quick. A hard-wired or gas unit, a heavy built-in, a basement or an upper floor, and cold storage that needs refrigerant recovery sit higher.
Answers 4 problemsGas Smell After a Hookup: Leave the House, Then Call
Water Leak After an Install: Close the Supply Valve First · Unit Too Big for the Opening: Cutout, Depth and the Delivery Path · New Appliance Not Level: Rocking Cabinets and Uneven Gaps
Comes up most onCold storage
Cooking appliances · Dish care · Laundry
Old appliance disconnect and removal,
step by step.
Clean the opening, check the floor and the wall behind for old damage, and leave it ready for the new unit.
Turn off the breaker, the water valve and the gas valve for the old unit, and confirm each is off.
Disconnect gas, water, drain and power, capping or closing each so nothing is left open.
Empty the unit, secure its doors, and move it out on sliders or a dolly over protected floors.
Arrange disposal or recycling that fits the unit, including refrigerant recovery for cold storage.
Clean the opening, check the floor and the wall behind for old damage, and leave it ready for the new unit.
The problems
it answers.
4 of them, from gas smell after a hookup: leave the house, then call to new appliance not level: rocking cabinets and uneven gaps.
All problems
Gas Smell After a Hookup: Leave the House, Then Call
6 causes, cheapest first
Before you call
Tell us this when you book
- The old appliance, its size and weight if you know them, and whether it is hard-wired, plugged, gas or plumbed
- Whether the new one arrives the same day, or the opening will stay empty for a while
- What should happen to the old unit: haul away, recycling program, donation or keeping it elsewhere in the house
- Stairs, a narrow hall or a finished floor on the way out
It also answers
Low,
on the site's scale.
A plugged-in unit on the ground floor is quick. A hard-wired or gas unit, a heavy built-in, a basement or an upper floor, and cold storage that needs refrigerant recovery sit higher.
Read the full cost guideWhere it
comes up most.
Most bookings: Cold storage, Cooking appliances, Dish care, Laundry.
All appliance typesOften the same visit
The makes
we see it on.
37 makes on this site, and the old appliance disconnect and removal on any of them. Each mark opens that make's own page.
All 37 brandsOld appliance disconnect and removal,
where we come out.
The home, the climate and the building all change how the old appliance disconnect and removal goes. These notes are about that, metro by metro.
All service areasTampa BayFL · 31 areas
Tampa Bay homeowners replacing an appliance before storm season often want the old unit out the same day, and old appliance disconnect and removal there closes its shutoffs, caps what needs capping and carries it out through the garage.
OrlandoFL · 30 areas
In Orlando vacation rentals old appliance disconnect and removal is booked between guests, with the old unit disconnected, the gas or water shut off and capped, and the path cleared before the new one arrives in the same visit.
Miami / South FloridaFL · 47 areas
South Florida condo towers often want an old appliance out on the same freight elevator slot that brings the new one in, so old appliance disconnect and removal there is timed to the building's booking window.
New York MetroNY · 75 areas
Carrying an old appliance down a New York walk-up is half the job, and old appliance disconnect and removal there plans the route, protects the stairwell and removes the doors if the unit will not turn at the landing otherwise.
HoustonTX · 36 areas
Houston garages often hold an old refrigerator or freezer that has not moved in years, and old appliance disconnect and removal there disconnects it, clears the space and checks the outlet and floor before the new unit goes in.
ChicagoIL · 50 areas
Getting an old washer and dryer up from a Chicagoland basement takes care on narrow stairs, so old appliance disconnect and removal there shuts off the water, caps the gas where the old dryer had it and removes the pair in the same trip.
Los AngelesCA · 95 areas
In Los Angeles old appliance disconnect and removal on a hillside lot may mean carrying a unit up outside steps to the street, so the path is walked first and the old unit's gas and water are closed and capped before it moves.
San DiegoCA · 31 areas
San Diego homeowners upgrading an appliance often want the old one gone the same day, and old appliance disconnect and removal there closes its shutoffs, caps what was connected and protects the floor on the way out.
San Francisco Bay AreaCA · 74 areas
When a Bay Area kitchen goes all-electric, old appliance disconnect and removal takes out the gas unit, closes its shutoff and leaves the line safe for the plumber who will cap it permanently, while the new unit waits on its new circuit.
Questions about
the old appliance disconnect and removal.
What happens to the gas valve if the new appliance arrives a week later?
Why does a cold storage unit need special disposal?
Should the old unit be emptied before the visit?
Back to your everyday
Ready to book the old appliance disconnect and removal?
Have these to hand: the old appliance, its size and weight if you know them, and whether it is hard-wired, plugged, gas or plumbed, whether the new one arrives the same day, or the opening will stay empty for a while, what should happen to the old unit: haul away, recycling program, donation or keeping it elsewhere in the house, stairs, a narrow hall or a finished floor on the way out.